Sign In
Sign-Up
Welcome!
Close
Would you like to make this site your homepage? It's fast and easy...
Yes, Please make this my home page!
No Thanks
Don't show this to me again.
Close
FINAL “Finishing” the panel
Remove all of the tape
Clean off marker lines (wd40 and rag works)
Wipe panel down with a clean rag
Re-buff using paint stripper wheel any marks that were made during the bending process.
Remember to use rags between the clamp and the panel.
Wash panel with soap and water
Install accessories and gauges.
I don’t have mounting hole points. You’re going to have to figure that out on your own.
Enjoy!
Home