Drawing out the Bezel

 

 

  1. Draw a line using a black permanent marker showing the where the bendís are.
  2. Using your drawing, mark the centers of all the holes, measuring from the edges of your panel using a #2 pencil and a ruler.
    1. When marking the center holes in the middle of the panel, its best to re-measure the panel to get your half way points. Take your over all measurement and divide it in half.
  3. Take your compass and put a marker in it. I used zip ties.
  4. Draw out each hole. You can use a piece of paper to set the compass to the radius of the hole and then draw the hole on the panel.

 

 



 Home